05-19-2017, 08:52 AM
Hey guys, I am running the Quest mode with the Latty Quest pack and have run into an issue.
On quest 788, Objective 1, Step 2, it needs to interact with a "Tiny Room Key" that is located on a thin tree coming out of a cliff. However, the bot keeps going in circles by falling off the cliff.
I can confirm that if I manually place the bot in front of and near the tree's start point, it will successfully navigate to the objective. Anywhere else, and it falls.
Edit: I am running 32bit with meshes that come with the bot.
On quest 788, Objective 1, Step 2, it needs to interact with a "Tiny Room Key" that is located on a thin tree coming out of a cliff. However, the bot keeps going in circles by falling off the cliff.
I can confirm that if I manually place the bot in front of and near the tree's start point, it will successfully navigate to the objective. Anywhere else, and it falls.
Edit: I am running 32bit with meshes that come with the bot.