08-23-2015, 02:18 AM
That worked! Though it revealed another issue, which is that instead of flying directly to the destination, it runs along the ground until it reaches the closest point to the destination on the contiguous surface on which I start, then runs right off the edge and flies in a straight line into the zone wall forever. The only console message I get that reveals anything is amiss is:
D = WARNING: ml_mesh_mgr.SwitchNavmesh: No Data-file exist: H:\\MINIONAPP\\Bots\FFXIVMinion\\Navigation\\Azys Lla.data".
I grabbed your mesh files from http://www.mmominion.com/Thread-Latty-s-...ard-meshes, which as of about 45 minutes ago was apparently updated. I'll grab the file pack there and see if that fixes this issue.
I just pulled down the mesh file a few hours ago, so I don't know what (if anything) would have been updated between now and then.
D = WARNING: ml_mesh_mgr.SwitchNavmesh: No Data-file exist: H:\\MINIONAPP\\Bots\FFXIVMinion\\Navigation\\Azys Lla.data".
I grabbed your mesh files from http://www.mmominion.com/Thread-Latty-s-...ard-meshes, which as of about 45 minutes ago was apparently updated. I'll grab the file pack there and see if that fixes this issue.
I just pulled down the mesh file a few hours ago, so I don't know what (if anything) would have been updated between now and then.