[that1guy]

For some reason when I make a new marker the bot runs to the marker, performs stealth, then just stands there not casting. If I cast manually the bot will reel in the fish but not recast the line. Any suggestions?

[brocklesnar]

did you set up the marker correctly? setting bait, level, etc?

[that1guy]

Yes, everything is set correctly.

[Jessix]

I have this same issue. I am using Latty's mesh for Dravanian Forelands. I load the mesh and click Show NavMesh and I can see the water in Hudred Throes is meshed. I create a fishing marker, set level and bait. I choose the single marker and hit start. My toon runs to marker, stealth's, and then just stands there.

If I cast my rod, then the bot will reel it in, but it wont recast.

[roberto_mm86]

I have this same issue. I am using Latty's mesh for Dravanian Forelands. I load the mesh and click Show NavMesh and I can see the water in Hudred Throes is meshed. I create a fishing marker, set level and bait. I choose the single marker and hit start. My toon runs to marker, stealth's, and then just stands there.

If I cast my rod, then the bot will reel it in, but it wont recast.

i suggest u to create your own mesh instead of latty mesh?

[Jessix]

The fact that I run to the marker should mean that the mesh is working.

I will test it in an old area and see if it works.

[Ace]

Can you check the Advanced Settings > Bot Status and see what task it is trying to perform?

[Jessix]

Sure, I am at work now, but I will post the results this evening.

Thanks Ace

[Jessix]

Here you go Ace.

[Ace]

It just stays in LT_FISH then?